In the previous article, we shared you an example of configuring double tag translation. This time, we are going to do single tag translation. Single tag translation is about where you map QinQ packets of a customer to a VNI of VxLAN and preserve the service as an inner VLAN inside
Few weeks back, Cumulus Networks announced new release of Cumulus Linux 3.3.1 which includes some early access features as following. SNMP enabled for routing protocols: Monitor BGP and OSPF using SNMP. VXLAN routing: An early access feature for configuring IP routing between VXLAN VNIs in an overlay network. QinQ: An early
For security reason, you are recommended to restrict remote access to your network via SSH or Telnet by allowing a certain whitelist IP addresses in order to prevent brute-force attack. If you own a Cisco IOS XR, you are coming to the right place. Here, we provide you the best and recommended way
In this article, we are going to talk about QinQ tunneling configuration between Juniper MX10 and Cisco ASR1001, it’s basically Junos and IOS. Before going to the main part, let start with some introduction so that you understand a little bit about QinQ. Understanding QinQ Tunneling QinQ (formally defined as 802.1ad) is
Doing VPN is like creating a private path from one site to another so that you can transfer data between each other off the untrust network. In order to get VPN tunnel established, IP address of each end must be known. There should be three different cases for VPN setup.
Dynamic Multipoint VPN (DMVPN) is available for at least 10 years I can say. Also, there are many blog posts including Cisco about this topic, but because I am preparing for an exam, I am doing a lab about it then why not share it here for iNET9s’ readers. Introduction to